Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Dimensions - Rear Name Badges And Emblems, A4 AVANT
- General Information - Name Badges and Emblems, Replacing. Refer to GENERAL INFORMATION - NAME BADGES AND EMBLEMS, REPLACING .
- Left Name Badge
- A4
A4
S4
RS4
Dimension -a- = 552 mm
Dimension -b- = 47 mm
Dimension -c- = 89 mm
- A4
- Right Name Badge
TFSI
1.4 T
2.0 T
35 TFSI
40 TFSI
45 TFSI
TDI
2.0 TDI
3.0 TDI
30 TDI
35 TDI
40 TDI
45 TDI
50 TDI
allroad
g-tron
40 g-tron
Dimension -a- = 552 mm
Dimension -b- = 47 mm
Dimension -d- = 89 mm
- Right Name Badge
quattro
Ultra
Dimension -a- = 552 mm
Dimension -b- = 47 mm
Dimension -d- = 89 mm
Dimension -e- = 17.5 mm
- Audi Emblem
Dimension -f- = 32.5 mm
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.