Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2019S5 PRESTIGE, 2D COUPEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 140 (COMMUNICATION)91 COMMUNICATIONSOUND SYSTEMOVERVIEW - SOUND SYSTEM8RM - BASIC SOUND SYSTEM
2019 Audi S5 Prestige, 2D Coupe
8RM - Basic Sound System
2019 Audi S5 Prestige, 2D CoupeSECTION 8RM - Basic Sound System
WARNING: This page is about a different car, the 2019 Audi S5 Sportback, 2019 Audi RS 5 Sportback, 2019 Audi A5 Sportback, 2018 Audi S5 Sportback, and 2018 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- One speaker in the left and right front doors
- One speaker on the left and right side of the instrument panel
- Two speakers each in the rear side trim panels/left and right rear doors
- Information Electronics Control Module 1 -J794- in the Glove Compartment
- Left Front Treble Speaker -R20- /Right Front Treble Speaker -R22- on Left and Right Sides of Instrument Panel
- Left Front Bass Speaker -R21- /Right Front Bass Speaker -R23- in the Lower Front Doors
- Left Rear Treble Speaker -R14- /Right Rear Treble Speaker -R16- in Rear Side Trim Panels/Top of Doors
- Left Rear Bass Speaker -R15- /Right Rear Bass Speaker -R17- in Rear Center Side Trim Panels/Bottom of Doors
- MOST Bus
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.