Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left And Right Front Treble Speaker 2 -R220- / -R221-, Removing And Installing: Removing
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the A-pillar trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connector from the Left Front Treble Speaker 2 -R220- -1-.
-- Remove the rivet -arrow- with a suitable drill bit.
-- Remove the Left Front Treble Speaker 2 -R220- -1-.
Always remove any shavings resulting from the drilling otherwise they may cause corrosion damage later.
If the paint on the door frame gets damaged during drilling, touch-up immediately.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.