Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Notes
Special tools and workshop equipment required
- Radio Removal Tool: T10057
- Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9 .
- Torque Screwdriver: VAG1624
The Information Electronics Control Module 1 -J794- is located in the glove compartment.
If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle Diagnostic Tester.
The Information Electronics Control Module 1 -J794- is located in the glove compartment. The cover frame of the Information Electronics Control Module 1 -J794- is connected to the glove compartment. The glove compartment must be removed first.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.