SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2019A5 QUATTRO PREMIUM PLUS, 2D CONVERTIBLEREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGAIR CONDITIONING [CONVERTIBLE]87 AIR CONDITIONINGDISPLAY CONTROL HEADDISPLAY CONTROL HEAD, REMOVING AND INSTALLINGFRONT A/C DISPLAY CONTROL HEAD -E87-, REMOVING AND INSTALLING, A4 AND A5INSTALLING
2019 Audi A5 Quattro Premium Plus, 2D Convertible

Front A/C Display Control Head -E87-, REMOVING AND INSTALLING, A4 AND A5: Installing

2019 Audi A5 Quattro Premium Plus, 2D ConvertibleSECTION Installing
GWWA87-12154Courtesy of AUDI OF AMERICA, LLC

-- Insert the Front A/C Display Control Head -E87- -B- in the receiving shaft from the trim -D- and press in until the tabs -A- click into place.

-- Check that the Front A/C Display Control Head -E87- -B- is seated correctly in the tabs -A- after replacing the trim -C-.

  • If the tabs -A- are not correctly engaged or holding, the Front A/C Display Control Head -E87- -B- must be secured with the bolts -C- and spring nuts -E- (for example flat-head bolts 4.0 x 12 mm N 104 159 and spring nuts N 105 110 01). Refer to the Parts Information) in the trim -D-.

-- If equipped, install the bolts -C-.

Reinstall in reverse order of removal. Note the following:

-- After installing the Front A/C Display Control Head -E87- check the DTC memory and if necessary erase. Use the Vehicle Diagnostic Tester.

-- If the Front A/C Display Control Head -E87- is replaced, complete the test plan using the Vehicle Diagnostic Tester.

Tightening Specification

Component Tightening Specification
Front A/C Display Control Head E87 on the trim 1.5 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.