Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 34 (WIPER/WASHER SYSTEMS)92 WIPER/WASHER SYSTEMSWINDSHIELD WIPER SYSTEMOVERVIEW - WINDSHIELD WIPER SYSTEMOVERVIEW - WINDSHIELD WIPER SYSTEM, RAIN/LIGHT RECOGNITION SENSOR
2018 Audi A5 Quattro Prestige, 2D Convertible
Overview - Windshield Wiper System, Rain/Light Recognition Sensor
2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Overview - Windshield Wiper System, Rain/Light Recognition Sensor
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2020 Audi S4, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi S4, and 2019 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Silicone Pad
- Replace after removing.
- Retaining Plate
- For Rain/Light Recognition Sensor -G397-
- Attached to the windshield
- Clip
- Rain/Light Recognition Sensor -G397-
- Equipped on some models: with Sunlight Photo Sensor -G107- and Humidity Sensor -G355-
- There are different versions. Refer to the Parts Catalog for the allocation.
- Removing and Installing. Refer to RAIN/LIGHT RECOGNITION SENSOR -G397-, REMOVING AND INSTALLING .
- Replacing. Refer to RAIN/LIGHT RECOGNITION SENSOR -G397-, REPLACING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.