Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 279 (INSTRUMENTS)90 INSTRUMENTSINSTRUMENT CLUSTEROVERVIEW - INSTRUMENT CLUSTER
2018 Audi A5 Quattro Prestige, 2D Convertible
Overview - Instrument Cluster
2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Overview - Instrument Cluster
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi A4 allroad, 2021 Audi A4 allroad, 2020 Audi A4 allroad, 2019 Audi A4 allroad, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 3 Nm
- Bolt
- 3 Nm
- Quantity: 2
- Instrument Cluster (9S5, 9S7)
- There are different versions. Refer to the Parts Information.
- With Instrument Cluster Control Module -J285-
- Do not disassemble
- The instrument cluster must be replaced if there is a malfunction.
- Removing and Installing. Refer to INSTRUMENT CLUSTER WITH Instrument Cluster Control Module -J285-, REMOVING AND INSTALLING, 9S5, 9S7 .
- Connector
- For the instrument cluster
- Fiber-Optic Cable, Connector (9S7)
- Only instrument cluster mid
- Seal with Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9
- Fiber-Optic Cable, Connector (9S8, 9S9)
- Seal with Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9
- Antenna Wire
- Connector
- For the instrument cluster
- Instrument Cluster (9S8, 9S9)
- With Instrument Cluster Control Module -J285-
- Do not disassemble
- The instrument cluster must be replaced if there is a malfunction.
- Removing and Installing. Refer to INSTRUMENT CLUSTER WITH Instrument Cluster Control Module -J285-, REMOVING AND INSTALLING, 9S8, 9S9 .
- Bolt
- 3 Nm
- Quantity: 2
- Instrument Cluster Trim
- Removing and Installing. Refer to INSTRUMENT CLUSTER TRIM, REMOVING AND INSTALLING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.