Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 224 (WIPER/WASHER SYSTEMS)92 WIPER/WASHER SYSTEMSWINDSHIELD WASHER SYSTEMOVERVIEW - WINDSHIELD WASHER SYSTEM
2018 Audi A5 Quattro Prestige, 2D Convertible
Overview - Windshield Washer System
2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Overview - Windshield Washer System
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi A4 allroad, 2021 Audi A4 allroad, 2020 Audi A4 allroad, 2019 Audi A4 allroad, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Grommet
- Replace if damaged
- Windshield Washer Pump -V5-
- For the front and rear window washer system
- Removing and installing. Refer to WINDSHIELD WASHER PUMP, REMOVING AND INSTALLING .
- Washer Fluid Reservoir
- For front/rear window washer system and headlamp washer system
- Removing and installing. Refer to WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .
- Grommet
- For washer fluid hose/wiring harness in the body
- Grommet
- For the washer fluid hose in the hood
- Washer Fluid Hose
- To the washer nozzles
- Right Washer Nozzle
- With Right Washer Nozzle Heater -Z21-
- Removing and installing. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to WASHER NOZZLES, ADJUSTING .
- Left Washer Nozzle
- With Left Washer Nozzle Heater -Z20-
- Removing and installing. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to WASHER NOZZLES, ADJUSTING .
- Cap
- For the filler neck
- Screen
- Grommet
- Replace if damaged
- Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .
- Nut/Bolt
- 8 Nm
- Quantity: 2
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.