Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 162 (IGNITION/GLOW PLUG SYSTEM [CZPB,CZRA,DBFB,DKZB,DKZC,CZPC,DKZA,DKVA,DKVB,CZPA])28 IGNITION/GLOW PLUG SYSTEMIGNITION SYSTEMKNOCK SENSOR 1 -G61-, REMOVING AND INSTALLINGINSTALLING
2018 Audi A5 Quattro Prestige, 2D Convertible
Knock Sensor 1 -G61-, Removing And Installing: Installing
2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Installing
WARNING: This page is about a different car, the 2020 Audi A3, 2019 Audi A3, and 2018 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Pay attention to the installation position.
-- Install the Engine Temperature Control Actuator -N493-. Refer to ENGINE TEMPERATURE CONTROL ACTUATOR -N493-, REMOVING AND INSTALLING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.