SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 162 (IGNITION/GLOW PLUG SYSTEM [CZPB,CZRA,DBFB,DKZB,DKZC,CZPC,DKZA,DKVA,DKVB,CZPA])28 IGNITION/GLOW PLUG SYSTEMIGNITION SYSTEMENGINE SPEED SENSOR -G28-, REMOVING AND INSTALLINGREMOVING
2018 Audi A5 Quattro Prestige, 2D Convertible

Engine Speed Sensor -G28-, Removing And Installing: Removing

2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Removing
WARNING: This page is about a different car, the 2020 Audi A3, 2019 Audi A3, and 2018 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Open the clip -2- and free up the coolant hose -1- and push to the side.

GWWA19-12595Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the clip upward from the air duct pipe.

Vehicle with Transmission Coolant Valve -N488- :

Fig 1: Transmission Coolant Valve -N488- Component Location
GWWA19-12596Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.

-- Remove the nuts -arrows- and move the coolant valve to the side.

Continuation for All Vehicles:

Fig 2: Identifying Engine Speed Sensor And Bolt
GWWA24-11207Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.

-- Remove the bolt -arrow- and remove the Engine Speed Sensor -G28-.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.