Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 159 (FRONT SUSPENSION)
2018 Audi A5 Quattro Prestige, 2D Convertible
Section 159 (Front Suspension)
2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Section 159 (Front Suspension)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2020 Audi S3, 2020 Audi RS 3, 2020 Audi A3 Quattro, 2020 Audi A3, and 2019 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
- 40 Front Suspension
- Front Axle
- SUBFRAME
- Suspension Strut And Upper Control Arm
- Lower Control Arm And Ball Joint
- Wheel Bearing
- Drive Axle
- Overview - Drive Axle
- Overview
- Drive Axle, Inner CV Joint 108 Mm Diameter - Bolted
- Drive Axle, Inner CV Joint 100 Mm (3.93 In.) Diameter - Bolted
- Overview - Input Shaft With Inner CV Joint, Inserted In Transmission
- Drive Axle With Triple Roller Joint AAR2600I/AAR3300I, Mounted In Transmission
- Drive Axle With Triple Roller Joint AAR2600I/AAR3300I, Mounted On Transmission Stub Shaft
- Drive Axle With CV Joint, Mounted On Transmission Stub Shaft
- Drive Axle With Triple Roller Joint AAR 2600I, Bolted
- Drive Axle Threaded Connection, Loosening And Tightening
- Drive Axle Heat Shield, Removing And Installing
- Drive Axle, Removing And Installing
- Left Drive Axle, Removing And Installing
- Right Drive Axle Bolted Inner Joint
- Drive Axle With Triple Roller Joint AAR3300I, Mounted In Transmission
- Drive Axle With Triple Roller Joint AAR3300I, Mounted On Transmission Stub Shaft
- Left Drive Axle With CV Joint, Connected To Inner Splines
- Right Drive Axle With CV Joint, Connected To Inner Splines
- Drive Axle, Disassembling And Assembling
- 108 Mm Inner CV Joint, Servicing
- 100 Mm (3.93 In.) Inner CV Joint, Servicing
- Drive Axle With Inner CV Joint, Installed In Transmission, Servicing
- Drive Axle With Triple Roller Joint AAR3300I, Installed In Transmission, Servicing
- Drive Axle With Triple Roller Joint AAR2600I/AAR3300I, Servicing, Mounted On Transmission Stub Shaft
- Drive Axle With CV Joint Attached With Inner Splines, Servicing
- Drive Axle With Triple Roller Joint AAR 2600I, Servicing, Bolted
- Drive Axle, Disassembling And Assembling, TENSIONING Lock Washer
- Outer CV Joint, Checking
- Inner CV Joint, Checking
- Overview - Drive Axle
- Special Tools
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.