Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rearview Camera -R189-, CALIBRATING
Special tools and workshop equipment required
- Calibration Tool - Wheel Center Mountings: VAS6350/1
-- Establish the requirements. Refer to Calibration Requirements .
-- Connect Vehicle Diagnostic Tester.
: VAS6350/1 installing:
-- Check which hole circle the rims have.
-- Equip the : VAS6350/1 appropriately.
-- To do so, secure the three wheel bolt adapters in the hole circle to each Calibration Tool - Wheel Center Mountings: VAS6350/1 .
-- Place the paddle on both : VAS6350/1 and secure them using a clamping screw.
-- Place the : VAS6350/1 onto the wheel bolts on the rear wheels.
The : VAS6350/1 are positioned by the "O-rings" in the adapters and secured.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.