SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 137 (COMMUNICATION)91 COMMUNICATIONNAVIGATION SYSTEMCONNECTOR ASSIGNMENTSCHIP CARD READER CONTROL MODULE -J676
2018 Audi A5 Quattro Prestige, 2D Convertible

Chip Card Reader Control Module -J676

2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Chip Card Reader Control Module -J676
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2020 Audi S3, 2020 Audi RS 3, 2020 Audi A3 Quattro, 2020 Audi A3, and 2019 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

Chip Card Reader Control Module J676 

Fig 1: Chip Card Reader Control Module -J676-
GWWA91-12293Courtesy of AUDI OF AMERICA, LLC
  1. 4-Pin Connector -T4ac- for Information Electronics Control Module 1 -J794- /USB Distributor -R293-
  2. 10-Pin Connector -T10z-
  3. Connection from the Close Range Communication Antenna -R269-

1 - 4-Pin Connector T4ac 

GWWA91-12098Courtesy of AUDI OF AMERICA, LLC

All pins are connected to the Information Electronics Control Module 1 -J794- /USB Distributor -R293-.

  1. Data (+)
  2. Supply, +5 V
  3. Data (-)
  4. Ground

2 - 10-Pin ConnectorT10z 

GWWA91-11317Courtesy of AUDI OF AMERICA, LLC
  1. Supply (+) Traffic Data Antenna -R173-
  2. Supply (-) Traffic Data Antenna -R173-
  3. Data to the Traffic Data Antenna -R173-
  4. Data from the Traffic Data Antenna -R173-
  5. Not Assigned
  6. Switch-on signal from Information Electronics Control Module 1 -J794-
  7. Diagnosis 1 Traffic Data Antenna -R173-
  8. Diagnosis 2 Traffic Data Antenna -R173-
  9. Supply (+) Chip Card Reader Control Module -J676-
  10. Supply (-) Chip Card Reader Control Module -J676-
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.