Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Information Electronics Control Module 1 -J794-, FROM MY 2017
Information Electronics Control Module 1 J794, except North America
- LTE connection from LTE Antenna 2 -R306-
- LTE connection from LTE Antenna 1 -R297-
- DAB connection from Digital Radio Antenna -R183-
- Connection block with four multi-pin connectors
- MOST Bus
- 4-Pin Connector -T4ej- to the Front Information Display Control Head -J685-
- 4-Pin Connector -T4ef- to the USB Distributor -R293-
- 4-Pin Connector -T4dx- to the Instrument Cluster -KX2-
- Not assigned/not equipped
- AM/FM/FM2 antenna connection
- GPS Connection from GPS Antenna -R50-, only for NZ0
Information Electronics Control Module 1 J794, North America only
- LTE connection from LTE Antenna 2 -R306-
- LTE connection from LTE Antenna 1 -R297-
- SDARS connection from Satellite Tuner Antenna -R172-
- Connection block with four multi-pin connectors
- MOST Bus
- 4-Pin Connector -T4ej- to the Front Information Display Control Head -J685-
- 4-Pin Connector -T4ef- to the USB Distributor -R293-
- 4-Pin Connector -T4dx- to the Instrument Cluster -KX2-
- Not assigned/not equipped
- AM/FM/FM2 antenna connection
- GPS Connection from GPS Antenna -R50-
Unlisted connector terminals are not assigned.
4 - Connection Block with Four Multi-Pin Connectors
A - 8-Pin Connector T8ag
- Right Rear Speaker (+)
- Right Front Speaker (+)
- Left Front Speaker (+)
- Left Rear Speaker (+)
- Right Rear Speaker (-)
- Right Front Speaker (-)
- Left Front Speaker (-)
- Left Rear Speaker (-)
B - 12-Pin Connector T12x
- Microphone input (+) from Microphone Unit In Front Roof Module -R164-, Telephone Microphone -R38-
- Not Assigned
- Not Assigned
- LF (+) from Control Module for Emergency Call Module and Communication Unit -J949-
- LF mute wire from Control Module for Emergency Call Module and Communication Unit -J949-
- CVBS cable (-) for the Rearview Camera System Control Module -J772-
- Microphone input (-) from Microphone Unit In Front Roof Module -R164-, Telephone Microphone -R38-
- Not Assigned
- Not Assigned
- LF (-) from Control Module for Emergency Call Module and Communication Unit -J949-
- Not Assigned
- CVBS cable (+) for the Rearview Camera System Control Module -J772-
C - 12-Pin Connector T12y
All pins are connected to the External Audio Source Connection -R199-.
- LF-In Ground
- Right LF-In
- USB, +5 V
- USB, Ground
- Not Assigned
- Not Assigned
- Left LF-In
- LF-In ground shielding
- Not Assigned
- Not Assigned
- Not Assigned
- Not Assigned
D - 8-Pin Connector T8j
9 - Subwoofer -R211- (+)
10 - Center Speaker -R208- (+)
13 - Subwoofer -R211- (-)
14 - Center Speaker -R208- (-)
17 - Terminal 31
18 - Terminal 30
E - 12-Pin Connector T12w
- CAN bus high to the Multimedia System Control Head -E380- /Front Information Display Control Head -J685-
- Reset Multimedia System Control Head -E380-
- Ring-break Diagnostic Cable
- Not Assigned
- Switch-on signal to Telephone Baseplate -R126-
- CAN bus high, Infotainment
- CAN bus low to the Multimedia System Control Head -E380- /Front Information Display Control Head -J685-
- Reset (Information Electronics Control Module 1 -J794-) from Multimedia System Control Head -E380-
- Not Assigned
- Not Assigned
- Status signal from Telephone Baseplate -R126-
- CAN bus low, Infotainment
5 - MOST bus
- Input
- Output
6 - 4-Pin Connector T4ej
All pins are connected to the Front Information Display Control Head -J685-.
- LVDS (-)
- Ground
- LVDS (+)
- Ground
7 - 4-Pin Connector T4ef
All pins are connected to the USB Distributor -R293-.
- USB1 data (+)
- USB2 data (-)
- USB1 data (-)
- USB2 data (+)
8 - 4-Pin Connector T4dx
All pins are connected to the Instrument Cluster -KX2-.
- LVDS (-)
- Ground
- LVDS (+)
- Ground
10 - AM/FM1/FM2 Antenna Connection
- Connector 2, AM/FM1 from Antenna Amplifier -R24-, Antenna -R11-
- Connector 1, FM2 from Antenna Amplifier 2 -R111- or Antenna Amplifier 3 -R112-, Radio Antenna 2 -R93-
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.