Overview - External Multimedia Device Connection, Through My 2016

2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Overview - External Multimedia Device Connection, Through My 2016
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2020 Audi S3, 2020 Audi RS 3, 2020 Audi A3 Quattro, 2020 Audi A3, and 2019 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

There are several External Audio Source Connection -R199- versions:

  • AMI (Audi music interface)
  • AMI (Audi music interface) - USB charging
  • AUX IN
  • AUX IN - USB charging

>>USB charging<< is the USB Connection Baseplate -R193-

The External Audio Source Connection -R199- is connected to the Information Electronics Control Module 1 -J794-

Component Location AMI, UE7

Fig 1: Component Location AMI, UE7
GWWA91-12027Courtesy of AUDI OF AMERICA, LLC

The connection -1- is located in the center console storage compartment -2-.

AMI Component Location - USB Connection BaseplateR193, UE7

Fig 2: AMI Component Location - USB Connection Baseplate -R193-, UE7
GWWA91-12000Courtesy of AUDI OF AMERICA, LLC

The connections -1- are located in the center console storage compartment -2-.

Component location AUX IN jack, UE3

Fig 3: Component location AUX IN jack, UE3
GWWA91-12025Courtesy of AUDI OF AMERICA, LLC

The connection -1- is located in the center console storage compartment -2-.

AUX IN component location - USB Connection BaseplateR193

Fig 4: AUX IN component location - USB Connection Baseplate -R193-
GWWA91-12026Courtesy of AUDI OF AMERICA, LLC

The connection -1- is located in the center console storage compartment -2-.

Either an AMI or AUX IN jack is installed.

Different external audio sources can be connected to the External Audio Source Connection -R199- :

  • iPod
  • MP3 player
  • USB Stick

Suitable adapter cables are needed. Refer to the Owner's Manual.

Fault Finding is performed using the "Guided Fault Finding"Β  on the Vehicle Diagnostic Tester.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.