Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine, Supporting In Installation Position
Special tools and workshop equipment required
- Engine Support Bridge:10-222A
- Engine Support Bridge - Engine Bracket:10-222A/1A
- Engine Support - Bracket w/Spindle and Hook:10-222A/10
Procedure
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Position the :10-222A with the :10-222A/10 -1- and the :10-222A/1A as shown on the right and left fender bolting edge.
-- Engage the carabiner hook -2- from the :10-222A/10 -1- on the engine lifting eyes.
-- Slightly pretension the engine/transmission assembly with the spindle, do not lift.
Assembling
Assemble in the reverse order of removal. Note the following:
-- Remove the :10-222A from the engine.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.