Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Module/Digital Sound System Amplifier, Removing And Installing, Coupe/SPORTBACK: Removing
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Open the storage compartment on the left side of the luggage compartment.
The bracket with the Digital Sound System Control Module -J525- must be removed first.
-- Release and disconnect the connectors -1- from the Digital Sound System Control Module -J525- -2-.
-- Insert the : VAS6223/9 -1- onto the MOST bus connector -2-.
-- Remove the nuts -arrows- on the bracket and remove the Digital Sound System Control Module -J525- -2- with the bracket.
-- Remove the bolts -arrows- and remove the Digital Sound System Control Module -J525- -1- from the bracket -2-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.