Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Peripheral Camera -R246-, REMOVING AND INSTALLING: Removing
The Rear Peripheral Camera -R246- has a trailing cable pig tail. The vehicle wiring harness couplings are located in the rear lid.
-- Remove the rear lid trim panel, refer to Luggage Compartment Trim Panels .
-- Release and disconnect the connectors -4- on the Rear Peripheral Camera -R246- -1-.
-- Remove the bolt -3-.
-- Remove the retaining plate -2-.
-- Remove the Rear Peripheral Camera -R246- -1- from the handle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.