Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Night Vision System Control Module, Removing And Installing: Removing
The Night Vision System Control Module -J853- is located in the front left footwell.
If replacing the control module, select the "Replace Control Module" function see Vehicle Diagnostic Tester.
-- Loosen the front left seat and with the wires still attached and push rearward, refer to Front Seats .
-- Remove the floor mat.
-- Remove the sill panel, refer to Passenger Compartment Trim .
-- Remove the foot rest, refer to Passenger Compartment Trim .
-- Remove the cover -1- for the emergency release -arrows-.
-- Disengage the carpet and push aside, while doing this guide the cover -1- for the emergency release through the opening.
-- Release the clips in the direction of the -arrow-.
-- Open cover -1-.
-- Release connectors -1 and 2- and remove from the Night Vision System Control Module -J853- -3-
- First release connector -2- and then -1-.
-- Push the retaining tab in the direction of the -arrow- and remove the Night Vision System Control Module - 853- -3- from the E-box.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.