Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Traction Battery -A2- Inlet Air Guide, Removing And Installing: Removing
-- Turn off the ignition.
-- Remove the rear outlet air guide for the traction battery. Refer to TRACTION BATTERY -A2- REAR OUTLET AIR GUIDE, REMOVING AND INSTALLING .
-- Remove the front outlet air guide for the traction battery. Refer to TRACTION BATTERY -A2- FRONT OUTLET AIR GUIDE, REMOVING AND INSTALLING .
-- Remove the left and right bolts -3 and 7-, if equipped.
-- Release the front and rear tabs -8- and remove the inlet air guide -1- from the battery cooling module -6-.
-- Unclip and remove the inlet air guide carefully from the retainers -4- on the left -2- and right -5- air guides.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.