Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Memory Seat/Steering Column Adjustment Control Module Bracket, Removing And Installing: Removing
- Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the memory seat/steering column adjustment control module. Refer to MEMORY SEAT/STEERING COLUMN ADJUSTMENT CONTROL MODULE, REMOVING AND INSTALLING .
-- Press the pin -2- toward the cushion and out of the clip -arrow A- on the bracket -1-, for example, using an upholstery needle.
-- Remove the pin from the seat pan.
-- Remove the bracket support -2- from the seat pan upper frame.
-- Unclip the clip -arrow A- on the seat pan upper frame -1-.
-- Disengage the locking tabs -arrow B- (quantity: 2).
-- Carefully remove the bracket from the seat pan in the direction of the -arrow-.
-- Remove the bracket from the seat pan.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.