Front Final Drive Overview

Front Final Drive Overview

• Refer to => [ Repair Information ] Repair Information.

• Refer to => [ Clean Working Conditions ] Clean Working Conditions.






1 Torque Converter

• Overview, refer to => [ Torque Converter Overview ] Torque Converter Overview

2 Shaft Seal

• For the torque converter

• Removing and installing, refer to => [ Torque Converter Shaft Seal ] Torque Converter Shaft Seal

3 Shaft Seal

• For the left flange shaft

• Between the final drive and the transmission housing

• Removing and installing, refer to => [ Left Flange Shaft Seal ] Left Flange Shaft Seal

4 Adjusting Shim

• Behind the taper roller bearing outer race

5 Taper Roller Bearing Outer Race

6 Bolt

• Tightening specification and sequence, refer to => [ Front Final Drive Cover - Tightening Specifications and Sequence ]

7 Shaft Seal

• For the right flange shaft

• Removing and installing, refer to => [ Right Flange Shaft Seal ] Right Flange Shaft Seal

8 Locking Ring

• Replace

9 Right Flange Shaft

• Removing and installing, refer to => [ Right Flange Shaft ] Right Flange Shaft

10 Drain Plug

• For the hole for checking and filling

• For the transmission fluid inside the front final drive

• Tightening specification - item 5 - => [ (Item 5) Drain Plug ] Transmission Drain and Inspection Plug Overview

11 Cover

• For the front final drive

• Pay attention to the alignment sleeves

12 Adjusting Shim

• Behind the taper roller bearing outer race

13 Taper Roller Bearing Outer Race

14 O-ring

• On the front final drive cover

• Removing and installing, refer to => [ Front Final Drive Cover O-ring ] Front Final Drive Cover O-ring

15 Differential

16 Transmission

17 Spring Pin

• Removing and installing, refer to => [ Shaft Seal, Parking Lock Emergency Release Transmission Selector Lever ] Removal and Replacement

18 Gearshift Lever

• For the parking lock emergency release

• Removing and installing, refer to => [ Shaft Seal, Parking Lock Emergency Release Transmission Selector Lever ] Removal and Replacement

19 Shaft Seal

• On the parking lock emergency release transmission selector lever

• Removing and installing, refer to => [ Shaft Seal, Parking Lock Emergency Release Transmission Selector Lever ] Removal and Replacement

20 Left Flange Shaft

• Removing and installing, refer to => [ Left Flange Shaft ] Left Flange Shaft

21 Bolt

• 9 Nm + 60° turn

• Replace

22 Gear Carrier

• Use the circlip to attach together with the mount - item 23 - => [ (Item 23) Bearings ] - item 24 - => [ (Item 24) Circlip ] to the left flange shaft.

• Is identified together as the left flange shaft mounting bracket.

23 Bearings

• For the left flange shaft

24 Circlip

• For the left flange shaft bearing

Front Final Drive Cover - Tightening Specifications and Sequence





- Tighten the bolts in two steps in the sequence shown: