Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A8 QUATTRO SEDAN (4H2) V8-4.2L (CDRA)REPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMHEADLINERSERVICE AND REPAIRREAR ROOF PANEL TRIM ASSEMBLY OVERVIEW
2012 Audi A8 Quattro Sedan (4H2) V8-4.2L (CDRA)
Rear Roof Panel Trim Assembly Overview
2012 Audi A8 Quattro Sedan (4H2) V8-4.2L (CDRA)SECTION Rear Roof Panel Trim Assembly Overview
Rear Roof Panel Trim Assembly Overview
1 Roof panel trim
• Removing and Installing, refer to => [ Roof Panel Trim ] Roof Panel Trim
• Press it against the body and against the D-pillar until it clicks into place
2 Clip
• Quantity: 6
• Remove clips left in the mounting points of the body and use for installation in the trim
• Replace any damaged or deformed clips.
• Insert in the roof panel trim
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.