SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A8 QUATTRO SEDAN (4H2) V8-4.2L (CDRA)REPAIR AND DIAGNOSISBODY AND FRAMEEXTERIOR MOULDING / TRIMDESCRIPTION AND OPERATIONSIDEMEMBER TRIM PANEL ASSEMBLY OVERVIEW
2012 Audi A8 Quattro Sedan (4H2) V8-4.2L (CDRA)

Sidemember Trim Panel Assembly Overview

2012 Audi A8 Quattro Sedan (4H2) V8-4.2L (CDRA)SECTION Sidemember Trim Panel Assembly Overview






Sidemember Trim Panel Assembly Overview






1 Bolt

• 8 Nm

2 Trim Strip

• For the sill panel trim

• Removing and Installing, refer to => [ Sill Panel Trim Molding ] Sill Panel Trim Molding

3 Nut

• 8 Nm

4 Front bracket

• For the sill panel trim

• Removing and Installing, refer to => [ Front Bracket for Sill Panel Trim ] Front Bracket for Sill Panel Trim

5 Fitting screw

• 8 Nm

6 Rear bracket

• The hooks - arrows - must lock into the sill panel trim when being installed.

• Removing and Installing, refer to => [ Rear Bracket for Sill Panel Trim ] Rear Bracket for Sill Panel Trim

7 Fitting screw

• 1.5 Nm

8 Bolt

• 8 Nm

9 Bolt

• 8 Nm

10 Sill panel cover

• Removing and Installing, refer to => [ Sidemember Trim Panel ] Sidemember Trim Panel

11 Expanding Pin

• Quantity: 5

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.