Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Auxiliary Heater Control Module -J364-, Connector Views
2012 Audi A7SECTION Auxiliary Heater Control Module -J364-, Connector Views
Double Connector -T2az-/6-Pin Connector -T6k-
| T6k (C) | Designation |
|---|---|
| 1 | CAN-Bus Instrument Cluster, High B708 Instrument Cluster CAN Bus - High Connection 1 (in main wiring harness) Data Bus On Board Diagnostic Interface J533 |
| 2 | CAN-Bus Instrument Cluster, Low B709 Instrument Cluster CAN Bus - Low Connection 1 (in main wiring harness) Data Bus On Board Diagnostic Interface J533 |
| 3 | Engine Coolant (EC) Switch-Off Valve (heater) N279 |
| 4 | Metering Pump V54 |
| 5 | Terminal 31, to 380 Ground Connection 15 (in main wiring harness) 43 Ground Connection (on right lower A-pillar) |
| 6 | Auxiliary Heater RF Receiver R64 |
| T2az (B) | Designation |
|---|---|
| 1 | Terminal 30, from Fuse Panel F SF |
| 2 | Terminal 31, to 379 Ground Connection 14 (in main wiring harness) 43 Ground Connection (on right lower A-pillar) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.