Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A6 SEDAN (4G2) L4-2.0L TURBO (CAEB)REPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPSERVICE AND REPAIRHALOGEN HEADLAMPSSEALING FRAME
2012 Audi A6 Sedan (4G2) L4-2.0L Turbo (CAEB)
Sealing Frame
2012 Audi A6 Sedan (4G2) L4-2.0L Turbo (CAEB)SECTION Sealing Frame
Sealing Frame
• Headlamps must be adjusted after performing measures that could influence headlamp adjustment. Refer to => [ Halogen Headlamp, Adjusting, ] Testing and Inspection.
Removing
- Remove headlamp housings. Refer to=> [ Headlamp Housing ] Headlamp Housing.
- Detach the frame - 2 - from the top and bottom of the headlamp housing - 1 - - arrows - and remove it.
Installing
Install in reverse order of removal. Note the following:
- Install the headlamp housing. Refer to => [ Headlamp Housing ] Headlamp Housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.