SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2012A4 2.0T AVANT QUATTROREPAIR AND DIAGNOSISELECTRICALHORNSCOMMUNICATION (AVANT)91 COMMUNICATIONDESCRIPTION AND OPERATIONNAVIGATION SYSTEM OVERVIEWS AND CONNECTORSMMI NAVIGATION, BASIC PLUS, SYSTEM OVERVIEW
2012 Audi A4 2.0T Avant Quattro

MMI Navigation, Basic Plus, System Overview

2012 Audi A4 2.0T Avant QuattroSECTION MMI Navigation, Basic Plus, System Overview
Fig 1: Identifying MMI Navigation
GWWA91-10988Courtesy of AUDI OF AMERICA, LLC
  1. Instrument Cluster Control Module -J285- in the instrument panel
  2. Steering Column Electronics Control Module -J527- on steering column at steering column switch
  3. Multifunction Steering Wheel
  4. Front Information Display Control Head -J685- in center of the instrument panel
  5. Multimedia Control Head -E380- in the center console
  6. Radio, Telephone, Navigation System Antenna -R52- roof antenna
  7. Window Antenna
  8. Antenna Amplifier 3 -R112- Behind the left luggage compartment side trim panel
  9. Navigation System With Cd Drive Control Module -J401- in the left side of the glove compartment
    • Contains front information display control head control module -J523- /radio -R- /CD player -R89-
  10. Data Bus On Board Diagnostic Interface -J533- Behind the glove compartment on the left side
  11. Digital Sound System Control Module -J525- behind the luggage compartment left side trim
  12. Sound Systems
  13. Microphone Unit In Front Roof Module -R164- inside the Front Interior Lamp -W1-
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.