Special Tools

2012 Audi A4 2.0T Avant QuattroSECTION Special Tools
Fig 1: Identifying Special Tools -- Cooling System, Draining And Filling
GWWG19-10013Courtesy of AUDI OF AMERICA, LLC

Special tools and workshop equipment required 

  • Adapter V.A.G 1274/8 Adapter for V.A.G 1274 Tester V.A.G 1274/10
  • Hose Clip Pliers V.A.G 1921
  • Cooling System Charge Unit VAS 6096
  • Drip Tray for VAS 6100 VAS 6208
  • Refractometer T10007

Special tools and workshop equipment required 

  • Cooling System Tester V.A.G 1274 B
    Fig 2: Cooling System Tester V.A.G 1274 B
    GWWW00-10657Courtesy of AUDI OF AMERICA, LLC
  • Adapter V.A.G 1274/9
    Fig 3: Adapter V.A.G 1274/9
    GWWW00-0564Courtesy of AUDI OF AMERICA, LLC
  • Hose Clamps Up to 25 mm Dia. 3094
    Fig 4: 3094 Hose Clamps
    GWWW00-0079Courtesy of AUDI OF AMERICA, LLC
  • Hose Clip Pliers V.A.G 1921
    Fig 5: Hose Clamp Pliers V.A.G 1921
    GWWW00-0464Courtesy of AUDI OF AMERICA, LLC
  • Hose Clip Pliers VAS 6340
    Fig 6: Hose Clamp Pliers VAS 6340
    GWWW00-10380Courtesy of AUDI OF AMERICA, LLC
  • Insert Tool 12 mm T10360
    Fig 7: Assembly Tool T10360
    GWWW00-10515Courtesy of AUDI OF AMERICA, LLC
  • Thrust Piece T10353
    Fig 8: Identifying Thrust Piece T10353
    GWWW00-10472Courtesy of AUDI OF AMERICA, LLC
  • Used Oil Collecting and Extracting Device V.A.G 1782
    Fig 9: Identifying Oil Extractor V.A.G 1782
    GWWW00-10211Courtesy of AUDI OF AMERICA, LLC
  • Engine Bung Set VAS 6122
    Fig 10: Engine Bung Set Plugs VAS 6122
    GWWW00-10435Courtesy of AUDI OF AMERICA, LLC
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.