Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Preheating Element
Special tools and workshop equipment required
- Hose Clip Pliers VAS 6362
Removing
-- Remove the noise insulation -1-. Refer to Removal and Installation .
-- Drain coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .
-- Loosen the hose clamp and remove the coolant hose from the connection -arrow A-.
-- Disconnect the connector on the engine preheating element -- -arrow D-.
-- Loosen the coolant hose clamp and remove the coolant hose from the connection -arrow E-.
-- Open the clamp -arrow B- and remove the engine preheating element -arrow C- downward.
Installing
Installation is in reverse order of removal, note the following:
-- Fill with coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .
-- Install the noise insulation. Refer to Removal and Installation .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.