Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SUBFRAME Mount Overview
2009 Audi A6 BaseSECTION SUBFRAME Mount Overview
WARNING: This page is about a different variant/trim than selected.
- Torque Support Stop
- Must contact torque support buffer at top and bottom without play
- Bolt
- 40 Nm
- Torque Bracket
- Removing and installing, refer to TORQUE SUPPORT
- Nut
- 40 Nm
- Bolt
- 75 Nm
- Right Engine Mount Bracket
- Removing and installing, refer to RIGHT ENGINE MOUNT
- Engine Mount, Right
- Removing and installing, refer to RIGHT ENGINE MOUNT
- Bolt
- 40 Nm
- Nut
- 40 Nm
- Right Engine Support
- Removing and installing, refer to RIGHT ENGINE MOUNT
- Left Engine Support
- Removing and installing, refer to LEFT ENGINE MOUNT
- Nut
- 40 Nm
- Engine Mount, Left
- Removing and installing, refer to LEFT ENGINE MOUNT
- Left Engine Mount Bracket
- Removing and installing, refer to LEFT ENGINE MOUNT
- Bolt
- 75 Nm
- Nut
- 40 Nm
- Bolt
- 40 Nm
- Bolt
- 40 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.