Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Oil Pressure, Checking
Special tools and workshop equipment required
- Oil Pressure Gauge Kit VAG1342
Procedure
- Oil level OK
- Engine oil temperature approximately 80 °C (176 °F).
-- Remove the Oil Pressure Switch -F22-. Refer to Oil Pressure Switch -F22- .
-- Connect the Oil Pressure Gauge Kit VAG1342 into the opening for the oil pressure switch.
-- Attach the Oil Pressure Switch -F22- to the oil pressure gauge.
-- Start the engine.
- Oil pressure at idle: at least 1.2 bar (17.4) pressure.
- Oil pressure at 2000 RPM: at least 1.5 bar (21.7 psi) pressure.
Assembling
-- Install the Oil Pressure Switch -F22-. Refer to Oil Pressure Switch -F22- .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.