Safety precautions

2009 Audi A6 BaseSECTION Safety precautions
WARNING: This page is about a different car, the 2006 Audi A6 and 2005 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:

  • Do not touch or disconnect the ignition wires when the engine is running or turning at starting RPM.
  • Always switch the ignition off before disconnecting or reconnecting the wires for the injection and ignition system, including the high voltage wiring and test leads.
  • If the engine is to be cranked at the starting RPM without starting (e.g. for compression testing), disconnect the electrical connector from the ignition coils and the fuel injectors.
  • Always switch the ignition off before cleaning the engine.
  • Be sure to activate the vehicle features (radio/radio-navigation system, clock, electric window regulators) according to the owners manual when the battery is reconnected.
  • Switch the ignition off and remove the ignition key.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.