Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2009A6 BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (3.0L - ENGINE CONTROLS - FUEL INJECTION & IGNITION, ENGINE CODE(S): AVK, BGN)01 ON BOARD DIAGNOSTIC (OBD)READINESS CODEREADINESS CODE, GENERATINGOPERATION 2: ERASE DTC MEMORY
2009 Audi A6 Base
Operation 2: Erase DTC memory
2009 Audi A6 BaseSECTION Operation 2: Erase DTC memory
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Test conditions
- Engine stopped, ignition switched on
Display on VAS5051:
- Under -1- select diagnostic function "05 - Erase DTC memory".
NOTE:
The readiness code is reset when the DTC memory is erased and must be reproduced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.