Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI2009A6 BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (2.0L - TURBO GENERIC SCAN TOOL - MOTRONIC FUEL INJECTION SYSTEM, IGNITION SYSTEM, ENGINE CODE: BPG)ST GENERIC SCAN TOOLDIAGNOSTIC TROUBLE CODE (DTC) TABLESSAE P0XXX-DTCSSPEED AND IDLE CONTROL

2009 Audi A6 Base

Speed and idle control

2009 Audi A6 BaseSECTION Speed and idle control

WARNING: This page is about a different car, the 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

DTC

Error Message

Diagnostic Procedure

Monitor Strategy

Malfunction Criteria and Threshold Value

Secondary Parameters with Enable Conditions

Monitoring Time Length

Frequency of checks, MIL Illum

P0501

Vehicle Speed Sensor A Range/Performance

Check vehicle speed signal → Speed signal, checking .

Rationality Check.

VSS signal, 2 MPH

Fuel cut off, active
Vehicle speed, 1520-4520 RPM

4 Seconds

Multiple
2 DCY

P0506

Idle Air Control System RPM Lower Than Expected

Check Throttle Valve Control Module J338 → Throttle Valve Control Module J338 , checking .

Out of Range, Low.

Engine speed deviation, -80 RPM

Engine speed, idle
Accelerator PP, 0%

Fuel cut off, not active
Vehicle speed, 0 MPH

Purge fuel rate vs. injection rate, 0.18
Altitude, 2500 m

IAT, >60°C
ECT, >60°C

Engine load, 34.5%

4 Seconds

Multiple
2 DCY

P0507

Idle Air Control System RPM Higher Than Expected

Check Throttle Valve Control Module J338 → Throttle Valve Control Module J338 , checking .

Out of Range, High.

Engine speed deviation >80 RPM

Engine speed, idle
Accelerator PP, 0%

Fuel cut off, not active
Vehicle speed, 0 MPH

Purge fuel rate vs. injection rate, 0.18
Altitude, 2500 m

IAT, >60°C
ECT, >60°C

4 Seconds

Multiple
2 DCY

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.