Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Position System Interface Control Module -J843-, Removing
Removing vehicle position system interface control module -J843-
-- Press the tabs -arrow- on the bracket -1- and lift the Vehicle Positioning System Interface Control Module -J843- -2- out of the rear side of the bracket.
-- Remove the front door trim panel. Refer to FRONT DOOR TRIM .
-- Window regulator motor -2-.
-- Disconnect the connector to the Right Front Door Control Module -J387-.
-- Press the retaining tab in the direction of the -arrow- and disengage the door control module -1- on the door shell.
-- To install, insert the door control module -1- into the lower mounting point, tilt the top inward and lock it in place.
-- Remove the rear door trim panel. Refer to REAR DOOR TRIM .
-- Window regulator motor -2-.
-- Disconnect the connector to the Left Rear Door Control Module -J388-.
-- Press the retaining tab in the direction of the -arrow- and disengage the door control module -1- on the door shell.
-- To install, insert the door control module -1- into the lower mounting point, tilt the top inward and lock it in place.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.