Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Garage Door Opener Control Module J530, removing and installing
2009 Audi A6 BaseSECTION Garage Door Opener Control Module J530, removing and installing
Removing
- Remove front bumper cover → 63 - Bumpers Removal And Installation .
- Remove bolt - 3 - and remove retaining bracket - 4 -.
- Remove Garage Door Opener Control Module - 2 - out of bumper cover.
- Disconnect electrical harness connector - 1 -.
Installing
Installation is performed in reverse order of removal, noting the following:
- Install front bumper cover → 63 - Bumpers Removal And Installation .
Tightening torque
| Component | Nm |
| Garage Door Opener Control Module J530 to bumper cover | 2.5 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.