Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Drawer, Through 06.2006
Special tools and workshop equipment required
- Engine and Transmission HolderVAS 6095
- Fixture for Seat RepairVAS 6136
- Drawer
- Removing
-- Remove the seat. Refer to STANDARD FRONT SEAT .
-- Mount the Fixture for Seat RepairVAS 6136 on the Engine and Transmission HolderVAS 6095.
-- Attach the front seat to the Fixture for Seat RepairVAS 6136.
-- Pull handle -2- and pull out drawer -1-.
-- Insert a screwdriver with inserted bit into opening -5- and remove the bolt installed beneath.
-- Remove the screws -4- (2x).
-- Remove the screw -3-.
-- Remove drawer -1-.
- Installing
-- To install, perform the steps used in removal in reverse order.
- Handle
- Bolt
- Screws
Quantity: 2
- Opening
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.