SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2009A6 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKELECTRICAL EQUIPMENT92 - WINDSHIELD WIPER AND WASHER SYSTEMFRONT WINDSHIELD WASHER SYSTEM, SERVICINGADJUSTING SPRAY NOZZLES
2009 Audi A6 Base

Adjusting spray nozzles

2009 Audi A6 BaseSECTION Adjusting spray nozzles

Special tools, testers and auxiliary items required 

Fig 1: Identifying Adjustment Tool T10127 Equipped With Needle 3125/ 5 A
GW00007870Courtesy of VOLKSWAGEN UNITED STATES, INC.
  • Windshield Washer Aiming Tool T10127 equipped with needle 3125/5 A
Fig 2: Identifying Dimensions For Windshield Spray Jet Setting
GW00023918Courtesy of VOLKSWAGEN UNITED STATES, INC.

Setting

NOTE:
  • The adjustment dimensions indicate the required values for the driving vehicle, i.e. when standing still, the spray nozzles spray in a slightly offset manner.
  • Mark the four points on the windshield using a water soluble marker:
  • Dimension - a  - = 255 mm.
  • Dimension - b  - = 510 mm.
  • Dimension - c  - = 530 mm.
  • Dimension - d  - = 430 mm.
  • Locate points from every single nozzle using Windshield Washer Aiming Tool T10127.
  • If the spray area does not correspond to the specifications, the nozzle is contaminated and must be cleaned.

Cleaning the nozzle:

  • Remove nozzle → Washer nozzles, removing and installing .
  • Flush nozzle opposite to spray direction using clear water.
  • To remove remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.

If the spray area still does not correspond to the specifications:

  • Replace nozzle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.