Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2008A3 BASE, 2.0 E, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 9 (CONTROLS, HOUSING - DIRECT SHIFT AUTOMATIC TRANSMISSION 02E AWD)CONTROLS, HOUSINGSPECIAL TOOLS
2008 Audi A3 Base, 2.0 E, Automatic DCT
Special Tools
2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Special Tools
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Holding Plate VW 309
- Holding Fixture VW 313
- Transmission Support VW 353
- Holding Fixture VW 540
Special tools and workshop equipment required
- Engine Support Bridge 10 - 222 A
- Bracket for Engine 10 - 222 A /1
- Engine/Transmission Jack V.A.G 1383 A
- Transmission Support 3282
- Shackle 10 - 222 A /12
- Hose Clamps Up to 25 mm Dia. 3094
Special tools and workshop equipment required
- Oil Collecting and Extracting Device V.A.G 1782
- Adapter for Oil Filling VAS 6262 A
- Hose Clip Pliers VAS 6340
- Pry Lever - Rmv Outside Mirror 80 - 200
- Pin 3282/29
- Adjustment Plate 3282/42 A
- Engine Bung Set VAS 6122
- Hooks 3004
- Shop Crane VAS 6100
- Bracket T10013
- Socket and Extended Bit T10107
- Bracket 2024 A /1
- Hose Clip Pliers V.A.G 1275
- Removal Tool T40203
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.