Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2008A3 BASE, 2.0 E, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (CONTROLS, HOUSING - MANUAL TRANSMISSION 02Q FWD)
2008 Audi A3 Base, 2.0 E, Automatic DCT
Section 8 (Controls, Housing - Manual Transmission 02Q Fwd)
2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Section 8 (Controls, Housing - Manual Transmission 02Q Fwd)
WARNING: This page is about a different variant/trim than selected.
- 34 Controls, Housing
- General Information
- Description And Operation
- Shift Knob And Shift Lever Boot Assembly Overview
- Shift Mechanism Through My 2008 Assembly Overview
- Shift Mechanism From My 2008 Assembly Overview
- Shift Cable And Selector Cable Assembly Overview
- Transmission Shift Lever And Relay Lever Assembly Overview
- Transmission Component Overview
- Transmission Housing And Shift Mechanism Assembly Overview
- Input Shaft, Output Shaft, Differential And Shift Rods Assembly Overview
- SUBFRAME Mount Assembly Overview
- Transmission, Transporting
- Transmission Housing Assembly Overview
- Transmission Side Shift Mechanism Assembly Overview
- Clutch Housing Assembly Overview
- Specifications
- Removal And Installation
- Disassembly And Assembly
- Special Tools
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.