Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2008A3 BASE, 2.0 E, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (2.0L - COOLING SYSTEM - ENGINE CODE(S): BPY)19 COOLING SYSTEMGENERAL INFORMATIONCOOLING SYSTEM, DRAINING AND FILLINGNOTES
2008 Audi A3 Base, 2.0 E, Automatic DCT
Cooling System, Draining And Filling: Notes
2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Adapter V.A.G 1274/8
- Drip Tray VAS 6208
- Hose Clip Pliers V.A.G 1921
- Cooling System Charge Unit VAS 6096
- Refractometer T10007
Draining
NOTE:
Drained coolant must be stored in a clean container for disposal or reuse.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.