SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2008A3 BASE, 2.0 E, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 22 (2.0L - ENGINE ASSEMBLY - ENGINE CODE(S): BPY)10 ENGINE ASSEMBLYSPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Audi A3 Base, 2.0 E, Automatic DCT

Fastener Tightening Specifications

2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
Component Bolt Size Nm
Bracket to Body1, 2 - 20 + 90°
Bracket to Engine Mount1, 2 - 20 + 90°
Bolts and Nuts
  M6 10
  M8 20
  M10 45
  M12 65
Engine Mount to Body1, 2 - 40 + 90°
Engine Mount to Engine Support1, 2 - 60 + 90°
Engine Support to Engine - 45
Exceptions:
Clamp B+ to Starter - 16
Ground (GND) Cable to Transmission - 23
Pendulum Supports to Transmission1, 2 - 40 + 90°
Pendulum Supports to Subframe1, 2 - 100 + 90°
  • 1 Replace bolt
  • 2 90° corresponds to a quarter turn.

Engine/Transmission Fastening

Fig 1: Removing Bolts On Engine/Transmission Flange
GWWA37-0214Courtesy of AUDI OF AMERICA, LLC
Item Bolt Nm
1, 2 M12 X 65 80
3 1) , 4 1) M12 X 135 80
5 through 7 M10 X 60 40
8 M12 X 90 65
  • 1) Bolt with threaded pin M8
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.