Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SUBFRAME Mount, Checking Adjustment
-- Remove the engine cover and air filter. Refer to Removal and Installation .
-- Pull the EVAP canister with connected lines upward in direction of the -arrow- out of the retainer and lay it aside.
The following dimensions must be attained:
- The clearance between the engine support -2- and the right longitudinal member must be -a- = 16 mm.
- The casting edge of the engine support -2- must be parallel to the support arm -1- (dimension x = dimension x).
The dimension a = 16 mm, can for example also be checked with a suitable cylindrical rod.
If a clearance dimension is too small or too large, proceed as follows:
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.