Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Exhaust Flap Control Module
Removing
-- Disconnect the connector -1-.
-- Loosen the clamps -2- and -3-.
-- Remove the exhaust flap control module -J883-.
Installing
Installation is in reverse order of removal, note the following:
Installation position of the seal between the exhaust flap control module -J883- and NOx reservoir or reduction catalytic converter EXHAUST DOOR CONTROL UNIT WITH REDUCTION CATALYTIC CONVERTER ASSEMBLY OVERVIEW .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.