Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2008A3 BASE, 2.0 E, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (2.0L - GENERAL, TECHNICAL DATA - ENGINE MECHANICAL - ENGINE CODE(S): CBEA)00 GENERAL, TECHNICAL DATASPECIFICATIONSENGINE DATA
2008 Audi A3 Base, 2.0 E, Automatic DCT
Engine Data
2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Engine Data
WARNING: This page is about a different car, the 2013 Audi A3, 2012 Audi A3, 2011 Audi A3, and 2010 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
| Code letters | CBEA | |
|---|---|---|
| Displacement | liter | 1.968 |
| Output | kW at RPM | 103/4200 |
| Torque | Nm at RPM | 320/1750 to 2500 |
| Bore | diameter mm | 81.0 |
| Stroke | mm | 95.5 |
| Compression ratio | 16.5 | |
| CZ | at least | 51 |
| Ignition sequence | 1-3-4-2 | |
| Exhaust gas recirculation | yes | |
| Exhaust temperature control | yes | |
| Turbocharger | Turbocharger | |
| Glow plugs | Steel glow plugs | |
| Charge air cooler | yes | |
| Oxygen sensor regulation | Heated oxygen sensor (HO2S) 1 | |
| Particulate filter | yes | |
| Valve per cylinder | 4 | |
NOTE:
The Audi A3 with a 2.0L 4V TDI CR engine only has steel glow plugs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.