Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2008A3 BASE, 2.0 E, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (2.0L - GENERAL, TECHNICAL DATA - ENGINE MECHANICAL - ENGINE CODE(S): CBEA)00 GENERAL, TECHNICAL DATAGENERAL INFORMATIONENGINE NUMBER
2008 Audi A3 Base, 2.0 E, Automatic DCT
Engine Number
2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Engine Number
WARNING: This page is about a different car, the 2013 Audi A3, 2012 Audi A3, 2011 Audi A3, and 2010 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- The engine number (engine code and serial number) -arrow- is located at the front on the engine/transmission joint.
- In addition, a sticker with engine codes and serial number is affixed to the toothed belt guard.
- Engine codes beginning with C are four-digit.
- The first 3 digits of the engine code stand for displacement and the mechanical structure of the engine. They are stamped in the cylinder block, including the serial number.
- The fourth digit describes the engine output and torque and depends on the engine control module.
NOTE:
The 4-digit engine code is on the type plate, vehicle data label and engine control module.
Locations of the type plate and vehicle data label. Refer to 03 MAINTENANCE, DIAGNOSIS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.