Telephone System Component Locations

2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Telephone System Component Locations
Fig 1: Telephone System Component Overview
GWWA91-10391Courtesy of AUDI OF AMERICA, LLC
  1. CD Changer -R41-
    • Inside the glove compartment.
  2. Center Mid/High Range Loudspeaker -R158-
    • In front instrument panel, center.
  3. Telephone Baseplate -R126-
  4. Telephone Microphone -R38-
  5. Digital Sound System Control Module -R12-
    • Only with BOSE.
    • behind luggage compartment right side trim.
  6. Antenna -R11-
    • Ter/Sat/GPS/GSM.
    • Roof antenna.
    • Removing and installing, refer to ANTENNAΒ .
  7. Antenna Amplifier -R24-
    • On upper left of rear lid.
  8. Left Antenna Module -R108-
    • At the bottom of the rear lid on the left side.
  9. Amplifier with Bass Speaker in Left Luggage Compartment -R44- /Bass Speaker -R100-
    • Behind luggage compartment left side trim.
  10. Satellite Radio -R146-
    • Behind luggage compartment left side trim.
  11. Left Rear Midrange Speaker -R105- /Right Rear Midrange Speaker -R106-
    • In bottom of rear doors.
  12. Left Rear Treble Speaker -R14- /Right Rear Treble Speaker -R16-
    • In top of rear doors.
  13. Left Front Mid/Low Range Loudspeaker -R101- /Right Front Mid/Low Range Loudspeaker -R102-
    • In bottom of front doors.
  14. Telephone Transceiver -R36-
  15. Left Front Treble Speaker -R20- /Right Front Treble Speaker -R22-
    • In the center of the A-pillar.
  16. Radio -R-
    • In the top of the center console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.