Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Speed Sensor At Front Axle
Removing
-- Release connector -1- at speed sensor and disconnect.
-- Remove bolt -1-.
-- Pull speed sensor out from wheel bearing housing.
Installing
Installation is the reverse of removal, with special attention to the following:
-- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.
-- Turn the steering completely left and right, making sure that the speed sensor wiring has sufficient clearance.
Tightening Specifications
| Component | Nm | |
|---|---|---|
| Speed sensor to wheel bearing housing | 8 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.