Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intake Valves And Separating Valves, Mark 60EC, Basic Setting
It is possible to perform a basic setting to the intake valves only if the ABS control module was replaced.
Use vehicle diagnosis, testing and information system VAS 5051 B or VAS 5052.
Once the intake valve basic settings have been done, then a basic setting to the separating valves must be performed.
-- Connect the vehicle diagnosis, testing and information system VAS 5051 B or VAS 5052.
- Chassis
- Brake System
- 01- On Board Diagnostic (OBD) capable systems
- 03 ABS control module J104 MK 60EC
- 03 Functions ABS MK 60EC J104
- Intake valve basic setting
- Separating valve basic setting
Follow the instructions exactly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.