Removal & Installation

2008 Audi A3 Base, 2.0 E, Automatic DCTSECTION Removal & Installation
Applies ToNoteStandard HoursWarranty HoursSkill Level
FWD6.6C
Combination Procedure: CLUTCH: Remove & Replace:
Automatic DCT Trans, Dual Clutch1.4C
Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace:
In-Line4,Automatic DCT Trans, Rear0.7B
Combination Procedure: FLYWHEEL: Remove & Replace:
Automatic DCT Trans0.3C
Combination Procedure: OIL PUMP: Remove & Replace:
Automatic DCT Trans1.6B
Combination Procedure: TRANSMISSION ASSEMBLY: Replace:
0.6C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.